SARPROZ ©

Hi,

I have the same problem but my MATLAB version is R2017b. To solve this problem and extra information I have attached the lasterror and SARPROZ log files. When this error is fixed, is information announced here?

Thank you.

yess

radians per celsius degree

what units?

Hello dears
My study area is located in 2 subswaths of Sentinel images(iw1 & iw2). I am the new user of Sarproz and I do not know how to do this. If the steps or tutorial are available, please help me.
Thanks.

the fifth parameter that can be estimated from time series (range by default -.4 .4) is the thermal expansion.
check “estimate” and then analyze the output…

Where I could find seasonal model that You mentioned. Thermal I found but how it use?

I have deleted manualy all *-vh-*.tiff (not needed for interfereometry) files from all “rawdata”.safe/measurement/ catalogs. if you go /slc/ catalog you saw the raw data catalogs. Then try again.

this error happens because you are trying to merge 2 images consecutive in azimuth and a different polar mode (SINGLE/DUAL) is detected.
so, you should find two images (directories) dated 2017-01-30 and in one of them there are two polarization files (like HH and HV) and in an other one just one of them.
probably you deleted the polarization you…[Read more]

The infos you bring here are too limited for allowing us giving you processing suggestions.
You will be contacted by people in your region using Sarproz so that you can discuss better with them
Best

You are in update mode: a Master is present and you chose to keep it. Since that Master was extracted in a given subswath, you cannot change it.
If you want to change the subswath, you have to remove the previous Master.
How to do it?
Check the “All” flag and then press “Set orbits”. The sw will warn you that it is going to delete the existing…[Read more]

hi,
im newer in using sarproz. while im fill in SLC DATA processing, i need to change the subswath. but the update is not possible. how can i change that subswath? i use sentinel 1 data.
thank you.

regards,
Made

Sry yes both cases are done that.

can u attach the ext DEM in SAR coordinates? (fourth time)

Hi again
I have realy hard to understand thats happening.
i have stack of sentinel 1 images and I mada Small area PSInsar analysis. Estimating booth LT and H.
In result analysis may seen that major H residuals has positive values (out.png).As I understood correctly, then H should be Ex.Dem+residual H. So Relative height from ground should be…[Read more]

This issue is similar to the problem reported here:
https://www.sarproz.com/groups/sarproz-group/forum/topic/issue-related-to-mcr-component-cache/
delete the folder containing the cached version of main, as described there