SARPROZ ©

does this file C:Program FilesMATLABR2018atoolboximagesimagesprivateresampsep.mexw64 exist?

what is the output of “license(‘test’,’Image_Toolbox’)” at the matlab command prompt?

Please find the attached lasterror.mat

you need to include a lasterror.mat file

Hi,

I have problem updating to the newest version of SarProz (29. May),
whenever I try to update it via Manage Vesrsion model, I alwasy get the same error
“Unable to write file “C:SarProZarchivetmpmain.exe”.
The entry may be password-protected or encrypted.”

I always start SarProz with Run As Administrator. But, since today I have noticed
that…[Read more]

Hello Steffan,

Could you send the log of this new one to me as well? I will start to investigate from there. I will probably ask for more files but I will check see the log first for signs.

Thanks!

yuxiao

Dear friends,

I have good news and bad news…

Good news – Using “orbits only” coregistration parameter not only made coregistration much faster but also corrected the failed interferograms from before, excelent!

Bad news: There is still ramping, mostly in azimuth, and strange results.

A – First the ramping pairs:

B – Now the…[Read more]

Dear Yuxiao,

I have sent you the site log file to the provided email address.

In the meantime I will check out “orbits only” coregistration.

Thanks!

Hello Steffan,

Thanks for the post.

The first few azimuth ramps seem very likely to be caused by the initial coregistration accuracy not good enough. In the next paragraph, I will explain how to tackle this problem.

I am not sure about the ramps on the range direction, though. It might be orbital errors, but we need to check the logs.

The…[Read more]

So I re-cogistered the dataset (I know I didn’t have to, oh well) and increased the number of reference points to 500K. Didn’t notice any errors except S1_Stitching like before. Using Max Area for AOI selection.

Then I changed to MST graph I processed Interferograms. There still seems to be a lot of problems…

Ramping in numerous images, here…[Read more]

It still show the stop running message like I told yesterday.

open a terminal (command prompt), cd to the folder where main.exe is, launch the application from the terminal by typing “main.exe” and pressing enter, then tell us what messages you get

Hi , I have re-installed MCR V83 and added to the system path. The former message didn’t show again but the main.exe always stops running when I open it. I have changed to the win7 or vista settings but it still didn’t work…LOL

this means that the installation of the mcr was not successful
try again
and check if the directory where you installed it is in the system path. if not, add it manually to the system path